Electrical wiring in general refers to insulated conductors used to carry electricity, and associated devices. Materials for wiring interior electrical systems in building vary depending on: power demand, type of occupancy and size of the building and local regulations and environment in which the wiring must operate. The amount of current a cable or wire can safely carry depends on the installation conditions.

The plasterer usually shows up after the hangers have finished building all the internal walls, by attaching blue board over the frames of the house with screws. The plasterer is usually a subcontractor working in crews that average about three veterans and one laborer. The job of the laborer is to set up ahead of and clean up behind the plasterers, so they can concentrate on spreading the "mud" on the walls.

Traditional timber framing is the method of creating structures using heavy squared-off and carefully fitted and joined timbers with joints secured by large wooden pags (Large versions of the mortise and tenon joints in furniture it is a temporary structure that retails wet concrete and allows it to set to a desired form.

Rebar is a common steel bar or mesh of steel wires commonly used as a tension device in reinforced concrete and reinforced masonry structures to strengthen and hold the concrete in compression. The surface of the rebar may be patterned to form a better bond with the concrete. It is also known as reinforcing steel and reinforcement steel.

Structural steel is steel construction material, a profile, formed with a specific shape or cross section and certain standards of chemical composition and mechanical properties. Structural steel shape, size, composition, strength, storage, etc., is regulated in most industrialized countries.

Plumbing is the system of pipes, drains fittings, valves, valve assemblies, and device installed in a building for the distribution of water for drinking, heating and washing, and the removal of waterborne wastes. And the skilled trade of working with pipes, tubling and plumbing fixtures in such system.

Thermal insulation is the reduction of heat transfer (the transfer of thermal energy between objects of differing temperature) between objects in thermal contact or in range of radioactive influence. Thermal insulation can be achieved with specially engineered.

Formwork is the term given to either temporary or permanent molds into which concrete or similar materials are poured. In the context of concrete construction, the falsework supports the shuttering moulds. Depending on the application, various types can be utilized.

A good and growing Welding-career starts obviously with excellent training obtained at an outstanding welding Institution which offers a complete welding plan of study thoroughly organized and well conducted by experienced trainers.

A door is an opening or closing structure used to block off an entrance, typically consisting of an interior side that faces the inside of a space and an exterior side that faces the outside of that space.

The primary purpose of Precast Kerb & Drain Laying is to allow smooth flow of water and to prevent and water stagnation on surface of roads and pavements.

The suspended ceiling is developed to conceal the underside of the floor above and to offer acoustic balance and control in a room.

Tiling may refer to : The physical act of laying and size varies according to the user’s choice at the site of application.

Water proofing is treatment on the surface of a substrate to prevent water seepage through the substrate.

It is installation of tubing system that conveys liquid/gas and solid materials